When I got my last phone, a SE k850i, I was recommended to charge it fully once before I even turned it on. Does this apply today as well, for my coming HTC Desire HD?
Why was I recommended to do so in the first place?
All newer phones use Lithium polymer batteries.
Why is it Partially Charged?
To decrease their aging they are intended to be stored at 40% charge. This means when you receive your phone it should be at 40% charge, otherwise they will have aged your battery for you. (you are probably used to the effects of aging, like a 2 year old phone seeming to have very short battery life). When you get your phone you can use it until it is discharged, but they normally say 'charge it' because people will not notice the partial charge.
Do Not Fully Discharge
You should not fully worry about fully discharging, this is superstition to earlier battery technologies. Fully discharging a lithium battery is one of the best ways to make it fail. below a certain charge they will have their overcharge protection circuitry fail and you cannot charge it at all. I have seen studies that show that this makes up more than 75% of "failed" lithium batteries.
Lithium Battery Aging
Lithium batteries have a set number of charge discharge cycles before they fail. This might be a number like 500 cycles. You actually get more like 1000 cycles if you only discharge to 50% before recharge. Lithiums really do not like a deep discharge, I cannot stress this enough.
If you would like more information about lithium battery technology let me know, I can get you many links, just drop me a comment. I have a few answers on the electronics and robotics stack exchange about it.
Can I leave it plugged in all the time?Yes, and no. This is very dependent on whom makes your device.
For example, my Lenovo laptop will not apply a charge to the battery unless it is under 97%. When it does charge the battery it charges directly to 100%, then stops until the battery sags below 97%. Many laptops did not do this, on most just applying charge if it is not 100%. This would put the battery through thousands of charge cycles in a week when you are not using the battery. This ages a battery quickly.
If your phone maker took the time and paid the extra cash then your phone will stop charging once it reaches full charge and just power the system from the wall outlet. It is significantly more likely that your phone is charging your battery on a short cycle and aging it thoroughly.
Some people have some confusion from some of the myths that go about. The primary one is memory. As Battery University will say, this is mostly extinct, and actually applies to nickel-cadmium batteries. As was stated in a comment about crystals Battery university has in reference to nickel-cadmium:
Now, talking about Lithium batteries, which your phone uses, there is even more difference. To quote them battery university directly from their simple guidelines:
I understand how this may go against what you have been taught, but I am someone who not only has research this but uses lithium batteries in my day to day work as an engineer.
Most of the time, yes you have to charge the phone fully and then sometimes fully discharge it the first time you use it. Most of the time you'll be fine with the phone turned on while you charge it the first time, as long as it gets fully charged before unplugging it.
There are a few reasons for this, some historical, some practical. The historical reason is that with older battery tech, the battery had to go through a full charge/discharge cycle in order to keep the battery life high. Phones would be shipped with batteries that only had enough power in them for initial set-up, forcing the owner to do a full charge when they got home. The practical reason is that batteries don't maintain their charge indefinitely when they're unplugged, so although your phone may have been shipped with a battery that started off with a full charge, by the time it gets to you, it may already be very low.
No. You do not need to fully charge ANY battery to the max until usage. It does not matter if it's new, old, a phone, or even a remote. It does not affect the battery unless that battery has been over-used. So, what I am saying is, no. You do not need to fully charge something new before usage.
Thank you for your interest in this question.
Because it has attracted low-quality answers, posting an answer now requires 10 reputation on this site.
Would you like to answer one of these unanswered questions instead?