0

The Transformer Pad TF700T worked almost fine with the previous Cyanogenmod10. Today I updated the pad with the CM-Update Manager. It downloaded the cm10.1.2 update package and then booted recovery. After the installation was completed I found the pad stuck at boot loop.

The Cyanogenmod circle circuits but then stucks, waits for a few seconds and then the pad reboots and the same happens again.

I Hope anyone can help me.

Thanks in advance, mrstrauss

EDIT: I did a format of the cache partition as well as the dalvik cache. The result is still the same. It boots until the circle stops to circle and then it reboots.

Improve this question
4
  • Does it boot into safe mode successfully? Also, you might try to re-flash CM. Though not that often, but I've heard of cases where that helped. Wipe again, optionally factory-reset even, flash, do another wipe. If that doesn't help either, I'm out of ideas (except for going back to the last version you had working on the device).
    – Izzy
    Commented Sep 18, 2013 at 6:17
  • I did not find any hint on entering safe mode on the transformer pad. Reflashing the update did not solve the problem. I flashed the previous - working - version of CM and it seems to boot normally into android.
    – mrstrauss
    Commented Sep 18, 2013 at 12:43
  • So it's most likely a bug the specific CM version has with your device. You might wish to post that solution as answer, and accept it lateron to show a possible way to solve that issue.
    – Izzy
    Commented Sep 18, 2013 at 13:23
  • Bug still exists in the new 10.1.3 version.
    – mrstrauss
    Commented Sep 24, 2013 at 16:23

1 Answer 1

Reset to default
0

Installing the previous, working version solved the problem. After that an installation of the gapps zip-package may be required.

Improve this answer

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .