0

Nothing will make this message Go away This is after the device turned off half way though flashing.

enter image description here

Things i Have done.

Flashed With Odin 3.09 with Stock Fimware Downloaded From [sammobile.com][2]

Tried to use kies but the device is not shown and i have reinstalled the Drivers and rebooted.

Note: every other Version of Odin Fails to flash to the device.

enter image description here

Even after a Flash the Device will still Go back to Recovery Mode.

Odin 3.12 with flash error.

enter image description here

  • In what state was the device before you attempting to flash it? What error message do you get when flashing fails? Usually thi happens when the flashing process did not complete and can be fixed simply by flashing, ideally with a repair firmware (aka 4 files firmware) – esQmo_ Mar 30 '18 at 10:30
  • @esQmo_ Flashing dose not fail with Odin 3.09, When i got the device i could only get into download mode how ever i didn't wait long enough for the device to charge and it turned off half way though. – Neil Mar 30 '18 at 11:36
  • Weren't you able to get in the recovery? – esQmo_ Mar 30 '18 at 11:39
  • @esQmo_ no, now i can only get into is emergency recovery. – Neil Mar 30 '18 at 11:43
  • @esQmo_ update answer with error message i get with odin3 3.12 – Neil Mar 30 '18 at 11:49
0

Unless it is a hardware faillure (damaged eMMC), flashing a full firmware (aka repair firmware or 4 files firmware) may solved the problem.

Download repair firmware from here then proceed as you did beforen but preferably try flashing with the latest version of Odin (v3.12.3 actually)

The zip password is: www.gem-flash.com

Remember this:

  • BOOTLOADER, APBOOT = BL
  • PDA = AP
  • MODEM = CP
  • MULTI-CSC, HOME_CSC = CSC
  • I used Odin3 V3.12 and got. – Neil Mar 30 '18 at 12:41
  • <ID:0/003> DO NOT TURN OFF TARGET!! <ID:0/003> Get PIT for mapping.. <ID:0/003> <ID:0/003> There is no PIT partition. <OSM> All threads completed. (succeed 0 / failed 1) – Neil Mar 30 '18 at 12:41
  • Why is it even asking for a PIT file?! Did you check that option in Settings ? Do not check ''Re-Partition'' – esQmo_ Mar 30 '18 at 12:42
  • i didn't Check "Re-Partition" imgur.com/a/iEUbC – Neil Mar 30 '18 at 13:00
  • Oh I think I got it: the software checks for the PIT in the device and if it can't find it, throws the error. Now see if the forlder does contain a pit file then go to the PIT tab (next the Settings tab) and load that file then try flashing again. – esQmo_ Mar 30 '18 at 13:03

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.