0

The Transformer Pad TF700T worked almost fine with the previous Cyanogenmod10. Today I updated the pad with the CM-Update Manager. It downloaded the cm10.1.2 update package and then booted recovery. After the installation was completed I found the pad stuck at boot loop.

The Cyanogenmod circle circuits but then stucks, waits for a few seconds and then the pad reboots and the same happens again.

I Hope anyone can help me.

Thanks in advance, mrstrauss

EDIT: I did a format of the cache partition as well as the dalvik cache. The result is still the same. It boots until the circle stops to circle and then it reboots.

  • Does it boot into safe mode successfully? Also, you might try to re-flash CM. Though not that often, but I've heard of cases where that helped. Wipe again, optionally factory-reset even, flash, do another wipe. If that doesn't help either, I'm out of ideas (except for going back to the last version you had working on the device). – Izzy Sep 18 '13 at 6:17
  • I did not find any hint on entering safe mode on the transformer pad. Reflashing the update did not solve the problem. I flashed the previous - working - version of CM and it seems to boot normally into android. – mrstrauss Sep 18 '13 at 12:43
  • So it's most likely a bug the specific CM version has with your device. You might wish to post that solution as answer, and accept it lateron to show a possible way to solve that issue. – Izzy Sep 18 '13 at 13:23
  • Bug still exists in the new 10.1.3 version. – mrstrauss Sep 24 '13 at 16:23
0

Installing the previous, working version solved the problem. After that an installation of the gapps zip-package may be required.

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.