You can get the values easily but can't set them without root access because the files are read-only (`rw-r-r`) for "others".

##Get the values

1. Use [D. Gibbs's answer](https://android.stackexchange.com/a/109470/96277) to setup ADB. 
2. Launch Terminal/cmd in PC and enter:

        adb shell  
        find /proc/sys/net/ -type f | while read -r file; do echo $file $(cat $file); done

 * `find` will find the files under the location `/proc/sys/net/`. Tweak the location if the need arises.
 * `while read` will read each line of the previous output as a file,
 * `do` will allow execution of tasks (`echo` "filename" and show its value using `cat`),
 * `done` to complete the task.
 * Sources: [1](http://stackoverflow.com/a/1767402/4720957), [2](http://stackoverflow.com/a/7292853/4720957).

 Snippet of output:

        /proc/sys/net/core/dev_weight 64
        /proc/sys/net/core/message_burst 10
        /proc/sys/net/core/message_cost 5
        /proc/sys/net/core/netdev_budget 300
        /proc/sys/net/core/netdev_max_backlog 1000
        /proc/sys/net/core/netdev_tstamp_prequeue 1

3. You may save the output into a file by using `> <FILENAME>` at the end of the step 2's last command.
4. Some files won't be saved or shown because of file permissions. In that case, root the device and repeat the aforesaid steps using `su` after adb `shell` command.

## Set the values

Now that you've a table of file -> value, you can change the value using `echo`, provided that you've root access.

1. In the terminal, enter:

        adb shell 
        su 
        echo <VALUE> > <FILE_PATH>
 
 Change `<VALUE>` with the value you want to set and `<FILEPATH>` with the path of the file. E.g.
        
        echo 46 > proc/sys/net/core/dev_weight 

---

You can apply the steps in a terminal app on Android as well. Just make minor changes relevant to the environment, like `> <FILENAME>` in find command, and not using `adb shell`.